IMR Enduron® 8133

6 reviews for IMR Enduron® 8133

1. 

   Anonymous – May 21, 2024

   Been loading my 7Rem Mag with 8133 for the last two years. Have found it to be very accurate and consistent: sub 0.05 moa with es <20. Very happy with this product.

2. 

   Anonymous – June 17, 2024

   This was suggested by Holbrooks. I purchased a pound, experimented and found the proper grains for 338LM, 300gn Bergers.
   It makes repetitive holes at extra long distance. The occasional fliers are my fault, squeezing during the heartbeat stroke.
   Only problem is it is hard to find. When I receive emails, the stores are sold out, again.

3. 

   Anonymous – June 19, 2024

   I

4. 

   Anonymous – July 9, 2024

   Finally found a great powder for my 6.5 PRC Browning LR X-bolt. Dialed scope in at 100 yards using 143 ELD-X and 59.0 grains of IMR8133. Results were night and day compared to other powders. 4 shot groups at 100 covered with a dime! 200 yards nickel size groups. Amazing!!!

5. 

   Anonymous – July 10, 2024

   I started with a load a full grain less than max. It stuck the case and jammed my ejector into the bolt! Obviously way too hot. I tried another load 3 grains under max, still way too much pressure.

6. 

   Anonymous – July 21, 2024

   Start at their starting load! Their max load is way too much. I loaded some 212 grain eld-x with 107 grains of IMR8133 and it stuck the bolt in my accumark. I can’t even imagine what would happen if you put their suggested max load of 109 grains behind a 220 grain bullet. Hodgdon needs to rethink some of these numbers as I have noticed other calibers with max loads that are way too hot. I noticed their Retumbo load is way to hot as well.